6.1.7 Ethernet commands

These commands configure the management and data Ethernet ports including TCP/IP parameters.

DPMTU

Controls the MTU (Maximum Transmission Unit) used by the Ethernet ports: Increasing the MTU may improve throughput.

Default: 1514

Set syntax: set DPMTU [DPn] mp1] [1514 9014 ] Requires a SaveConfiguration command

Get syntax: get DPMTU

IPDHCP

Selecting DHCP allows the iPBridge to request an IP address from the network DHCP server. The network must have at least one DHCP server

Default: enabled

Set syntax: set IPDHCP [DPn] mp1 all] ] [enabled disabled]

Requires a SaveConfiguration command Get syntax: get IPDHCP [DPn] mp1 all]

EthernetSpeed

Specifies the speed of the Ethernet ports. If auto is enabled, the speed will be negotiated. Speeds 10 and 100 are half duplex 10 base T is only valid for the management port. If you want to run the iPBridge at 10baseT, you must set the Ethernet speed using this command. Choices are:

10 = 10 baseT

100 = 100 baseT

1000 =1000baseT Default: auto

Set syntax: set EthernetSpeed [DPn] mp1] [10 100 1000 Auto]

Requires a SaveConfiguration command

Get syntax: get EthernetSpeed [DPn] mp1 all]

Exit

Exits the current TCP/IP CLI session; it has no effect if used during a serial CLI session.

Immediate command: Exit

IPGateway

Controls the current gateway. If IPDHCP is enabled (see above), get command reports the current IP gateway assigned by the network DHCP server

Default: 0.0.0.0

Set syntax: set IPGateway [DPn] mp1 all] xxx.xxx.xxx.xxx

Requires a SaveConfiguration command Get syntax: get IPGateway [DPn] mp1 all]

IPSubnetMask

Controls the current subnet mask. If IPDHCP is enabled (see above), get command reports the current subnet mask assigned by the DHCP server

Default: 255.255.0.0

Set syntax: set IPSubnetMask [DPn] mp1 all] xxx.xxx.xxx.xxx

Requires a SaveConfiguration command

Get syntax: get IPSubnetMask [DPn] mp1 all]

IPAddress

Controls the IP address of the iPBridge Ethernet data ports. If IPDHCP is enabled, the get command reports the current IP address assigned by the network DHCP server, followed by the DHCP identifier.

Default IP addresses: [10.0.0.1] [10.0.0.2] [10.0.0.3] [10.0.0.4] [10.0.0.5]

Set syntax: set IPAddress [DPn] mp1] xxx.xxx.xxx.xxx Requires a SaveConfiguration command

Get syntax: get IPAddress [DPn] mp1 all]

49

Password

Specifies a password for all sessions: TCP/IP, FTP and ExpressNAV web-based interface. You will be prompted for the current password, to enter the new password, and to confirm the new password. Passwords are case sensitive, 0-32 characters with no spaces.An empty password can be configured by entering the Password confirmation prompts with no parameters. The command RestoreConfiguration default sets the password to its default value.

Default: Password

Set syntax: set Password

Requires a SaveConfiguration command

ATTO Technology Inc. iPBridge Installation and Operation Manual

Page 58
Image 58
ATTO Technology 2700C operation manual Ethernet commands