SNTP
Controls the SNTP (Simple Network Time Protocol) settings for the iPBridge. When enabled, the iPBridge will try to contact a specified SNTP server at reset and every 12 hours after to initialize/synchronize the time.
Default: Enabled
Set syntax: set SNTP [enableddisabled]
Requires a SaveConfiguration command
Get syntax: get SNTP
SNTPServer
Controls the IP address of the SNTP time server that the iPBridge will contact to initialize/synchronize the time.
If the iPBridge is unable to contact the specified SNTP server within 30 seconds, the iPBridge will try to contact the first auxiliary SNTP time server. If the first auxiliary SNTP time server is not available, the iPBridge will try to contact the second auxiliary SNTP time server. If the second auxiliary SNTP time server is not available, the iPBridge will continue to approximate the time based on the most recent SNTP time server, physical real time clock or manual initialization/synchronization.
Auxiliary time servers
129.6.15.28
132.163.4.101
Set syntax: set SNTPServer [xxx.xxx.xxx.xxx] Requires a SaveConfiguration command Get syntax: get SNTPServer
SpeedWrite
When enabled, improves the performance of FCP WRITE commands to Fibre Channel devices attached to the iPBridge. Specify Fibre Channel fp for a specific Fibre Channel port or fpidx, or all for a list of the Speedwrite states of all currently mapped Fibre devices.
Default: disabled
Set syntax: set SpeedWrite fc [fp fcidx all] [enableddisabled]
Get syntax: get SpeedWrite fc [fp fcidx all]
SpeedWriteDefault
When enabled, SpeedWrite performance enhancement is set as the default for any subsequent Fibre Channel devices mapped manually or via an AutoMap operation. If disabled, the iPBridge will not attempt SpeedWrite performance enhancement to
Default: disabled
Set syntax: set SpeedWriteDefault [enabled disabled]
Get syntax: get SpeedWriteDefault
TailEventLog
Displays new events to the terminal during a serial or Telnet session.Press <ESC> to exit tail mode.
Immediate command: TailEventLog
Time
Controls the time for the iPBridge if SNTP has been disabled or is not available.
Set syntax: set Time [HH]: [MM]: [SS]
Requires a SaveConfiguration command
Get syntax: get Time
TimeZone
Controls the time zone for the iPBridge if SNTP has been disabled or is not available. Choices are EST, CST, MST, PST or numerical offset from GMT in the form of
Default: EST
Set syntax: set TimeZone [ [EST CST MST PST] [+ / - HH :MM ] ]
Requires a SaveConfiguration command Get syntax: get TimeZone
Username
Specifies username for all TCP/IP, FTP and ExpressNAV web server sessions.The username is case insensitive, 1- 32 characters, no spaces. Changes to the Admin Level Username will require an Admin Level password.
Default: root
Set syntax: set Username [username]
Requires a SaveConfiguration command
Get syntax: get Username
42 Interfaces: CLI
