ATTO Technology 2700C operation manual Diagnostic commands

6.1.4 Diagnostic commands

ATTO iPBridge diagnostic commands help validate iPBridge operation and diagnose/isolate iPBridge faults. Event logging is a mechanism for on-site observation of internal iPBridge 2700 behavior such as tracing Fibre Channel commands received over the GbE from the host and return of data and status to the host.

BridgeModel

Reports model information about a specific iPBridge

Get syntax: get BridgeModel

BridgeName

Specifies name used to identify individual iPBridge units. May be up to a maximum of eight characters. It is not the World Wide Name (WWN).

Set syntax: set BridgeName [value]

Requires a SaveConfiguration command

Get syntax: get BridgeName

ClearEventLog

Clears the contents of the event log. No events will be recorded until the command has been completed.

Immediate command: ClearEventLog

level will be masked when the command DisplayEventLog is issued.

Subsystem entries:	Log level entries:
FC	INFO
ENET	WARN
NVRAM	CRIT
PERF	FAIL
ECC	ALL
ALL

GEN

HTTP iSCSI

Default: disabled

Set syntax: set DisplayEventLogFilter [subsystem] [level] [enableddisabled]

Get syntax: get DisplayEventLogFilter [subsystem] [level]

ClearTraceLog

Clears the contents of the trace log. No events will be recorded until the command has been completed.

Immediate command: ClearTraceLog

DisplayEventLog

Displays the most recent page of event log entries. Typing a +, - or = causes the next, previous or same page of event log entries to be displayed. No events will be recorded until the command has been completed. Type <escape> to disable the command, begin new log entries, and return to CLI.

Immediate command: DisplayEventLog < + - = ESC>

DisplayEventLogFilter

Filters the display of data for specific iPBridge subsystems when in DisplayEventLog mode. If enabled for a particular subsystem and level, that subsystem and

DisplayTraceLog

Displays the most recent page of trace log entries. Typing a +, - or = causes the next, previous or same page of trace log entries to be displayed. No events will be recorded until the command has been completed. Type <escape> to disable the command, begin new log entries, and return to CLI.

Immediate command: DisplayTraceLog < + - = ESC>

DisplayTraceLogFilter

Filters the display of data for specific iPBridge subsystems when in DisplayTraceLog mode. If enabled for a particular iPBridge port, that port will be masked when the command DisplayTraceLog is issued.

Default: disabled

Set syntax: set DisplayTraceLogFilter [enabled disabled]

Get syntax: get DisplayTraceLogFilter

43

ATTO Technology Inc. iPBridge Installation and Operation Manual