Manual Target Management: iSCSI Target Management

ExpressNAV is the preferred interface for setting up targets and access to targets. This page allows you to set up and configure iSCSI targets individually for Access Control, Device Maps and iSCSI CHAP.

For the default target, Access Control and CHAP are disabled by default. For all manually-created targets, Access Control is enabled and CHAP is disabled by default.

Refer to Target management on page 11, and Mapping commands on page 53 for details.

Bridge Configuration

You must enter the current Admin password to change usernames or passwords. Other configurable options are

Minimum Operating Temperature

Maximum Operating Temperature

Operating Temperature Warning

Enable/disable Identify Bridge

Bridge Name

Restore Defaults

Refer to Maintenance commands on page 41 for details on each parameter.

Firmware Update

Use ExpressNAV to update firmware. For details, refer to Updating firmware on page 23.

Advanced CLI Configuration

Allows you to input any CLI command available through the iPBridge.

To use the Advanced Configuration page

1Type in the CLI command

2Click the Submit button: this is equivalent to typing in the CLI command into a TCP/IP or serial port CLI session.

A text field beneath the box will list the most recent commands issued to the iPBridge through this page.

If you enter an incorrect parameter, the CLI help text will be displayed, showing the parameters available.

3If your entry was correct, type saveconfiguration

4Click the Submit button. Your changes will be implemented.

Restart Firmware

Implements a firmware restart of the bridge and makes permanent any changes you have made since the last firmware restart.

Note

Restarting the firmware may take a few minutes.

1Click the Restart button.

A box will tell you to wait until the counter gets to 0 and then the browser will refresh.

2If the browser does not refresh after the counter gets to 0, click the link to refresh it manually.

Help

Gives help information about the command line interface commands and troubleshooting tips via links to pages with help text for each category of options and one link to the Troubleshooting Tips and FAQs page on the ATTO website,

www.attotech.com.

Contact information for ATTO technical support is on the right.

Help is always available by pressing any word shown in red on the screen.

Exhibit 3.1-1 CLI command entered incorrectly on the Advanced CLI page, error message with suggested solution, then correct entry with response.

22 Installation: ExpressNAV

Page 31
Image 31
ATTO Technology 2700C Manual Target Management iSCSI Target Management, Bridge Configuration, Firmware Update, Help