IsReserved
Displays the reservation status of the current iPBridge session/interface.
If set, the configuration image is being modified by another iPBridge services session: set commands are temporarily unavailable but information commands are available.
Executing a SaveConfiguration, RestoreConfiguration or FirmwareRestart RELEASES the iPBridge so that other services users may access it.
When iPBridge services interface is RESERVED, set commands from other users are unavailable.
At least one interface must always have access to the iPBridge.
Immediate command: IsReserved
Ping
Ping will send an ICMP echo request to the specified host.
Immediate command: ping [DPn] mp1] [xxx.xxx.xxx.xxx] <count <size>>
RMON
RMON collects and stores Ethernet data on data ports at specified intervals. You can display the entire table requested, or a single entry based on the index (and sample index for the Ethernet History table).
Entries in the Ethernet History table are not valid when the Sample Index is 0.
Setting the history control entries take effect immediately, but changes must be saved to be persistent over a reboot.
Valid range for EthernetStat index:
Valid range for historyControl and EthernetHistory index:
Valid range for historyControl buckets requested: 1- 180
Valid range for historyControl interval:
Set syntax: set RMON idx bucketsRequest interval [valid invalid]
Get syntax for entire table: get RMON [ethernetStat historyControl] <idx>
Get syntax for single index entry: get RMON ethernetHistory <idx sampleIdx>
RouteDisplay
Displays a list of iSCSI to Fibre Channel mappings. The optional LUN parameter will limit the list to the map which satisfies a search for the given LUN.
NumEntries: decimal number of map lines displayed
Target Name: target name
Lun : target LUN
Immediate command: RouteDisplay iSCSI <Target Name> <lun>
SerialNumber
Reports the FibreBridge serial number which is unique for each FibreBridge. The serial number tracks the board throughout its life and should not be changed for any reason. Set form requires operator privileges.
Information only: get SerialNumber
SNMPDumpMIB
Dumps the contents of the ATTO iPBridge private SNMP MIB to the current CLI session. Consult your network administrator for further assistance with SNMP.
Immediate: SNMPDumpMIB
SNMPExtendedTraps
Controls Extended SNMP map functioning such as device transition and device error. Consult your network administrator for further assistance with SNMP.
Set syntax: set SNMPExtendedTraps [enableddisabled]
Get syntax: get SNMPExtendedTraps
SNMPTrapAddress
Sets/displays the IP trap addresses and levels. Consult your network administrator for further assistance with SNMP.
Index: value between 1 and 6
IP Address: standard IP address
Trap Level: severity required for an event to trigger a trap: None: no traps will be sent to the address
ALL: all triggering events will be sent
Informational: a trap will be issued to the given address
Warning: warning and critical events will be sent
Critical: only critical events will trigger a trap
Set syntax: set SNMPTrapAddress [Index] [IPAddress] [none all warning critical ]
Get syntax: get SNMPTrapAddress
45
ATTO Technology Inc. iPBridge Installation and Operation Manual
