2.3 Additional configurations
Additional configurations to improve usability and security are available on the iPBridge 2700. Use ATTO ExpressNAV or the Command Line Interface.
Set the Real Time Clock
Before proceeding you should set the Real Time Clock. You can set the time automatically by using the Simple Network Time Protocol (SNTP). SNTP is enabled by default.
Note
The iPBridge must remain powered on for more than 24 hours to ensure the date and time are set.
1If you have not already, open an ExpressNAV session. Refer to Open an ExpressNAV session on page 19.
2Click Time & Date.
3If you are setting the time manually, proceed to the next step. If you are using a time server on your network to set the time, click Simple Network Time Protocol enabled.
a.Type the IP address of the time server in the Time Server text box.
Change the current username, password It is best practice to change the default username and password to a username and password significant to you.
1If you have not already, open an ExpressNAV session. For instructions, refer to Open an ExpressNAV session on page 19.
2Click Bridge.
The Bridge Configuration page is displayed. The username that you are currently logged in with is displayed in the Username text box.
3Enter appropriate information into the Username, Current Password, Old Password, New Password, and Confirm Password text boxes.
Note
The username is case insensitive and password is case sensitive.
4Click Submit.
5The username and password for all Telnet, FTP and ATTO ExpressNAV sessions is changed. b. Click Submit. Exit this procedure.
6If you are setting the time manually, click Simple Network Time Protocol disabled.
7Click Submit.
8Select a time zone from the Time Zone drop- down choices.
9In the box marked HH:MM:SS enter the desired time in hours, minutes, and seconds.
10In the box marked MM:DD:YYYY enter the desired month, day, and year in digits.
11Click Submit.
Create a read only password or username
You may set a read only password or a read only username. Refer to General use commands on page 39.
1If you have not already, open an ExpressNAV session.
For instructions, refer to Open an ExpressNAV session on page 19.
2Click Bridge.
The Bridge Configuration page is displayed. The username that you are currently logged in with is displayed in the Username text box.
3Enter the Admin password in the first line of the boxed area.
4Enter the desired information into the Admin
Username, New Admin Password, Confirm New Admin Password or New Read Only Password and Confirm New Read Only Password text boxes.
The username is case insensitive and password is case sensitive.
5 Click Submit.
The username or password for all Telnet, FTP and ATTO ExpressNAV sessions are changed.
17
ATTO Technology Inc. iPBridge Installation and Operation Manual
