3.1 ATTO ExpressNAV pages

Each page in the ATTO ExpressNAV interface provides information and/or configuration parameters based on a specific topic. Each page can be reached through the menu at the side of each page An image on each page’s header shows each port in the product faceplate. Each port is clickable and will also take you to the appropriate page.

Status

Displays iPBridge information

Bridge name

Vendor ID

Product ID

Firmware revision number

Serial number

Valid temperature range

Current temperature

Current voltage

Ethernet port IP addresses

Ethernet port status

Fibre Channel port status

World Wide Name identifiers for Fibre Channel ports and iSCSI nodes

Serial Port Configuration

Configure the baud rate and echo parameters. Refer to Serial port configuration commands on page 47 for details on each option.

Time & Date Configuration

Configures the real-time clock or accesses a remote time server. Configurable options are

Enable/disable Simple Network Time Protocol

Time Server

Time Zone

manually set time

manually set date

Refer to Maintenance commands on page 41 for details each parameter.

Ethernet (Network) Port Configuration Displays available ports and configures each port independently for the following parameters

Enable/disable DHCP

IP address

IP gateway

IP subnet mask

Ethernet speed

21

MTU

Refer to Ethernet commands on page 49 for details on each parameter.

SNMP

Configures Simple Network Management Protocol parameters and Trap recipient IP address for each Ethernet port. Refer to Ethernet commands on page 49 for details.

Fibre Channel Configuration

Each Fibre Channel port is configured separately. The page displays the Port Name and Node Name for each port. Choose the port to display a list of attached devices for each bus. Configurable options are

Hard Address assignment

Data rate

Connection mode

Hard Address values

Refer to Fibre Channel configuration commands on page 48 for details.

iSCSI Configuration

Configurable options are

iSCSI Alias

iSCSI Port Number

iSNSLoginControl

iSNSServer

SpeedWrite

Refer to iSCSI commands on page 51 for details on each parameter.

Auto Target Management

ExpressNAV is the preferred interface for setting up targets. On this page you can map devices automatically to the default target or map each device to its own target. By default, Access Control and CHAP are disabled.

Refer to Target management on page 11, and Mapping commands on page 53 for details.

ATTO Technology Inc. iPBridge Installation and Operation Manual

Page 30
Image 30
ATTO Technology 2700C operation manual Atto ExpressNAV pages