Installation
Final Check and Adjustments
BEFORE SWITCHING THE APPLIANCE ON
Before applying power to the unit for the first time, check for the following conditions:
jThe unit is level.
jAll electrical safety provisions have been ad- hered to and the electrical connections are correct.
jWater is connected, turned on and all of the connections are water tight.
jGrease filters are in their proper positions
jThe transport cart is inserted into the cooking cavity. When the cart is not inserted into the unit, water can spill onto the floor causing it to be- come slippery. If the door will not close properly, use the following adjustment procedure.
jCheck gas fittings with leak detection solution.
DOOR ADJUSTMENT
The hinges may be adjusted using the following procedure:
1.Adjust the top hinge plate by loosening the three mounting bolts on the top right corner of the unit.
2.Adjust the bottom hinge pin by loosening the mounting bolt located under the bottom hinge plate on the lower right corner of the oven.
3.Adjust the hinges so that the door back and the unit face are parallel.
4.Tighten the bolts so that there is no further movement.
5.The adjustment is correct when the door closes firmly and no steam leaks from the gasket.
The hinges can also be adjusted as follows:
1.Adjust the door catch by loosening the four mounting screws located on the inside sur- face of the oven door.
2.The adjustment is correct when no steam leaks from the gasket. DO NOT over com- press the door gasket. When closed the door should slightly compress the door gasket.
Oven |
Door |
Oven |
Door |
Figure 4
12