Blodgett DFG-200 manual Manager Level Programming Entering the programming mode, Programming hold

Operation

Blodgett IQ2T Control

MANAGER LEVEL PROGRAMMING Entering the programming mode

1.Press the PROG KEY (10). The top display reads CodE.

2.Use the product keys to enter the program- ming access code: 4 5 1 2. Press the ENTER KEY (14). The top display reads SYS.

Programming hold

Hold allows product to be kept warm in the oven at a programmed time and temperature by press- ing the HOLD KEY (9).

1.Press the SCAN KEY (15). The top display reads Hold. Press the TOGGLE/CLEAR KEY (11) to toggle between YES and no. Press the SCAN KEY (15).

If no is chosen:

a.) Press the SCAN KEY (15) to advance to programming the setback mode.

If yes is chosen:

a.) The top display reads HOLD. The bottom display gives the current hold time. Press the TOGGLE/CLEAR KEY (11). Use the product keys to enter a hold time from 0 to 9 hours. Press the SCAN KEY (15) to enter the new hold time (HR:MN)..

b.) The top display reads HOLD. The bottom display gives the current hold tempera- ture. Press the TOGGLE/CLEAR KEY (11). Use the product keys to enter a hold tem- perature from 140_F---210_F. Press the SCAN KEY (15) to enter the new hold tem- perature.

c.) The top display reads H FAn. The bottom display gives the current fan mode. To change the fan mode press the TOGGLE/ CLEAR KEY (11). The bottom display toggles between Hi and Lo. Press the SCAN KEY (15) to enter the new fan mode and continue with programming the set- back mode.

Programming the setback mode

The setback mode operates as a power saving feature. After a period of non-use (the setback time) the oven temperature automatically de- creases to the setback temperature. The oven will maintain this temperature until a product key is pressed. The minimum setback time is 20:00.

1.The top display reads SEtb. The bottom dis- play gives the setback mode. To change the setback press the TOGGLE/CLEAR KEY (11). The bottom display toggles between YES and no. Press the SCAN KEY (15).

If no is chosen:

a.) The controller advances to programming the temperature mode.

If yes is chosen:

a.) The bottom display gives the current set- back time. Press the TOGGLE/CLEAR KEY (11). Use the product keys to the en- ter the desired setback time. Press the SCAN KEY (15) to enter the new setback time.

b.) The bottom display gives the current set- back temperature. Press the TOGGLE/ CLEAR KEY (11). Use the product keys to the enter a setback temperature from 140_F---300_F. Press the SCAN KEY (15) to enter the new setback and continue with programming the temperature mode.

Programming the temperature mode (_F or _C)

1.The top display reads dEg. The bottom dis- play gives the units. To change the units press the TOGGLE/CLEAR KEY (11). The bottom display toggles between F and C.

2.Press the SCAN KEY (15) to enter the new temperature units and continue programming the shelf sensitivity.

30