Blodgett DFG-200, DFG-100 Troubleshooting Guide, Maintenance, Possible Causes, Suggested Remedy

Models: DFG-100 DFG-200

1 101
Download 101 pages 32.04 Kb
Page 50
Image 50
Troubleshooting Guide

POSSIBLE CAUSE(S) Maintenance

Troubleshooting Guide

 

POSSIBLE CAUSE(S)

 

SUGGESTED REMEDY

 

 

 

 

 

SYMPTOM: Oven will not fire.

 

 

 

 

 

 

S

Gas turned off.

S

Turn the gas valve to ON.

S

Oven not plugged in.

S

Plug in electrical supply cord.

S

Power switch on the control panel is off.

S

Set the control panel to COOK or OVEN ON.

S

Control set below ambient temperature.

S

Set to desired cook temperature.

S

Doors are open.

S

Close doors.

S Computerized controls --- error code on display.

S

*

 

 

 

 

 

SYMPTOM: Oven does not come to ready.

 

 

 

 

 

S The oven has not reached preheat temperature.

S

Wait for oven to reach preheat temperature.

S

Gas valve not turned on completely.

S

Check the gas valve, turn on fully if necessary.

S

The quick disconnect is not connected.

S Reconnect the quick connect. Check all gas

 

 

 

connections.

S

Gas pressure to oven is too low.

S

Call your local gas representative.

S Fan delay feature may be activated, if applicable.

S

Deactivate fan delay feature.

S Internal problem with main temperature control.

S

*

 

 

 

 

 

SYMPTOM: Convection fan does not run.

 

 

 

 

 

 

S

Oven is not plugged in.

S

Plug in electrical supply cord.

S

Oven is not set to the cook mode.

S

Set the control panel to COOK or OVEN ON.

S

Circuit breaker tripped.

S

Reset the breaker.

S Fan delay feature may be activated, if applicable.

S

Deactivate fan delay feature.

S

Doors are open

S

Close doors.

 

 

 

 

 

SYMPTOM: General baking problems.

 

 

 

 

 

 

S

Computerized controls --- incorrect product

S

Reprogram control per Operation section.

 

programming.

 

 

S

Thermostat out of calibration.

S

*

S

Improper oven venting.

S

*

 

 

 

 

*Denotes remedy is a difficult operation and should be performed by qualified personnel only. It is recommended, however, that All repairs and/or adjustments be done by your local Blodgett service agency and not by the owner/operator. Blodgett cannot as- sume responsibility for damage as a result of servicing done by unqualified personnel.

WARNING!!

Always disconnect the power supply before cleaning or servicing the oven.

46

Page 50
Image 50
Blodgett DFG-200, DFG-100 manual Troubleshooting Guide, Maintenance, Possible Causes, Suggested Remedy