Operation

Intelliplus with Chain Event Control

CHAIN EVENT PROGRAMMING

NOTE: Program keys 1 and 2 can have up to six events. Program keys 3-5 can have up to

4events.

1.Press the PGM MODE ON/OFF key (13) to en- ter the programming mode. PGM will blink. The normal operation of the oven is halted.

2.Press the desired PGM # key (11) to select an event chain to be programmed. The appropri- ate PGM # will blink and remain lit. Event #1 time and temperature are shown in the dis- play. E1 is displayed alternately with the tem- perature.

3.Rotate the TEMPERATURE dial (6) to set the temperature.

4.Select LOFAN or HIFAN by pressing the COOK HI/LO FAN key (9).

5.Select FAN CON or FAN CYC by pressing the FAN CON/CYC key (12). CYC remains lit if cycling fan is selected.

6.Rotate the TIME dial (5) to set the cook time.

NOTE: If the time is set to zero (0), the event is ignored.

7.Press the EVENT # key (14). Event #2 time and temperature are shown in the display. E2 is displayed alternately with the temperature.

8.Set the desired temperature, fan speed, fan mode and time.

9.Press the EVENT # key (14) to proceed to the next event. Enter the event parameters as de- sired. If HOLD mode is desired, it must be the last event in any chain. Any events stored after a HOLD mode will be ignored.

10.To program another chain of events, press a different PGM # key (11) then press the EVENT # key (14).

11.Store as many as five (5) programs using all the PGM # keys.

12.Press PGM MODE ON/OFF (13) to exit the pro- gramming mode. PGM # disappears from the display and normal oven operation resumes.

To add new programs or to change the parame- ters of an existing program, repeat steps 1-12 as necessary.

SELECTING A PROGRAM

1.To select a program sequence, press the de- sired PGM # key (11). PGM # will be illumi- nated. At this time the oven begins to heat up to the cook temperature stored in the event #1 chain. EI is illuminated and the E1 options are displayed. The amount of time displayed is the sum total time of all the programmed events.

2.Press the START TIMER key (7) to start a pro- grammed sequence of events.

3.Press the EVENT # key (14) to display the time remaining in the current event chain. The time will remain displayed for approximately 5 sec- onds.

4.Press the ACTUAL TEMP key (8) to display the actual temperature within the oven.

5.Press the CANCEL key (15) to stop an active program sequence.

WARNING!!

A complete five minute shutdown must be observed before the oven is relighted.

38

Page 42
Image 42
Blodgett DFG-200, DFG-100 manual Chain Event Programming, Selecting a Program