Bosch Appliances PT-400 Phone Number, Pager Password, Pager ID, Pager Group, Floor Level, Locate

Security Escort Technical Reference Manual 3.0 System Menus

and Screens

EN 15

Phone Number

This phone number is dialed to send a pager message to this subscriber. Typically, this is a different phone number than the one that is manually dialed to access this pager. The phone number is assigned by the paging service.

Pager Password

This is the password to be sent to the paging service when a page is sent to this subscriber. Leave blank if not required (typically the pager password is not required). The pager password is assigned by the paging service.

Pager ID

This is the ID that identifies the pager to receive the pager message (many times this value is the last seven digits that are manually dialed to access this pager). The pager ID is assigned by the paging service.

Pager Group

These are the pager groups that this subscriber is a member of. This subscriber can be a member of up to three different pager groups.

Pager Confirmation Not Required

If checked, the confirmation pager message is not sent to this pager if alarm is acknowledged by an acknowledgement transmitter.

Fixed Location Transmitter

This section is used only when this transmitter is mounted in a fixed location (it does not move). When this transmitter transmits an alarm, it is always reported at the programmed location.

Floor Level

This is the floor level where this alarm is located for a fixed location transmitter.

Map X Position

This is the X coordinate of the map position where this alarm is located for a fixed location transmitter.

Map Y Position

This is the Y coordinate of the map position where this alarm is located for a fixed location transmitter.

Locate

When clicked, the Edit Subscriber’s Advanced Features Screen disappears and the cursor changes to a cross hair. Moving the cursor to a point on the map and clicking the left mouse button scrolls the map to that point at the center of the screen.

When the map is showing the desired alarm location, move the cross hair to the exact location of the alarm to be reported and click the right mouse button. The Edit Subscriber’s Advanced Features Screen reappears and the selected location is entered into the X and Y coordinates.

If while the cross hair cursor is displayed, you want to exit without changing any coordinate values, press the [ESC] key and the Edit Subscriber’s Advanced Features Screen reappears.

Map Number

Defines which bitmap is displayed for the fixed location of this transmitter. The default map is zero, which corresponds to bitmap MAP0.EDB stored in the Escort sub-directory. Map 1 would be MAP1.EDB. There can be 100 maps per Security Escort System (0 to 99).

Bosch Security Systems 6/12 38947D