Bosch Appliances PT-400 Transmitting Point, Total Transmissions, Missed all Receivers, Enable Rec

Security Escort Technical Reference Manual 3.0 System Menus

and Screens

EN 52

Transponder

Select the transponder for the transmitting point and each receiving point. They can be on the same or different transponders.

Transmitting Point

Select the point (receiver) on the selected transponder to generate the transmissions.

Total Transmissions

The total number of times the designated receiver transmitted the test message.

Missed all Receivers

The total number of times that the test transmission, was not heard by any of the designated receivers.

Enable Rec

This box must be checked for this receiver to monitor the test transmissions.

Point

Select the point (receiver) on this transponder to monitor the test transmissions.

Hits

The number of times this receiver successfully heard the test transmission.

Misses

The number of times this receiver failed to hear the test transmission.

Highest

The left-hand box displays the highest receive level at which the test transmission was heard. The right-hand box displays the greatest number of packets heard from a single test transmission.

Average

The left-hand box displays the average receive level at which the test transmission was heard. The right-hand box displays the average number of packets heard from a single test transmission.

Lowest

The left-hand box displays the lowest receive level at which the test transmission was heard. The right-hand box displays the least number of packets heard from a single test transmission.

Run Test

The test only runs when this box is checked. To stop the test and retain the test values, uncheck this box.

Spacing

This slows the test by forcing this number of seconds between test transmissions. Normally, this setting is left at the default of 0.

Stop Test and Reset Counters

Clicking this button stops the test and resets all values.

Close Screen, Does Not Stop Test

Clicking this button closes this screen but does not stop the test from running. Reopening the screen displays the current progress of the test. The test should not be left running unless there is a specific need, as it generates both RF and system traffic.

3.3.15Network Status Screen

This screen shows the status of communications on the network, modem, and system serial ports.

Figure 500: Network Status Screen

Successful Incoming Messages

This value is the number of messages that the system successfully received on this communications port.

Incoming Communication Errors

This value is the number of messages that the system detected errors in, on this communications port. If displayed in yellow, this value is more than 1.5% of the Successful Incoming Messages.

Bosch Security Systems 6/12 38947D