
Security Escort Technical Reference Manual 3.0 System Menus and Screens
EN 51
Red LED - Strobe
If this checkbox is checked, the red LED output of a receiver or the strobe output of an alert unit is turned on if On is clicked, or off if Off is clicked. If this checkbox is not checked, the state of this output does not change.
Off
When clicked, the checked
On
When clicked, the checked
Ambient
The Ambient value is shown above Auto Advance displaying the current ambient level at the receiver. To get an updated ambient reading, select the point, click the Transmit button, and click the Ambient button.
RF Micro Version
The receiver’s RF micro revision level is shown below Auto Advance. To get an updated reading, click the Revision button.
Antenna
Normally, a receiver automatically switches between its diversity antennas during normal operation (leave the default selection on a working system at this setting). The receiver can be forced to use only the left or right antenna, or always switch by selecting the appropriate setting and clicking the Antenna button.
Ant Map
Clicking Ant Map causes the system to interrogate the current antenna switching settings of all receivers on this transponder.
Transmit
Clicking Transmit causes this receiver to send one test transmission.
Reset Point
Clicking Reset Point causes the microprocessors on this point to reset as if they were just powered up. A receiver should not be reset in a working system, as it can cause receptions to be lost.
Ambient
Clicking Ambient causes the system to interrogate the current ambient levels of all receivers on this transponder.
Revision
Clicking Revision causes the system to interrogate the RF micro revision levels of all receivers on this transponder.
Jamming
A receiver monitors the ambient level during normal operation. If the ambient level rises above the jamming setting and jamming trouble, it is reported to the central console. The receiver’s jamming level can be adjusted by selecting the appropriate setting (shown in hexadecimal levels) and clicking the Jamming button.
Jam Map
Clicking Jam Map causes the system to interrogate the jamming setting levels of all receivers on this transponder.
3.3.14Receiver Test Screen
Use this screen to set up and monitor four receivers and listen to one receiver transmitting with its Buddy Check Transmitter. Normally, the function is for engineering evaluation of new transmitter and receiver designs, but it can be used to test receiver boards and locations in a working system.
Figure 499: Receiver Test Screen
Bosch Security Systems 6/12 38947D