Bosch Appliances PT-400 manual Off Status Screen, On Output Command, Total Alarms Received

Security Escort Technical Reference Manual 3.0 System Menus	EN 45
and Screens

	Off	Status Screen
	When clicked, the checked horn-siren,
	green LED and strobe-red LED outputs
	are turned off for the selected point
	on the selected transponder. If the
	output does not change, click On Output
	Command and click Off again.
	On Output Command
	When clicked, the checked horn-siren,
	green LED, and strobe-red LED outputs
	are turned on for the selected point on
	the selected transponder. If the output
	does not change, click Off and then
	click On Output Command again.
	Transponder
	Selects the transponder you desire to
		Transponder
	communicate with.
	Previous	Selects the transponder you want to see
	Returns to the previous transponder.	the status of.
		Total Alarms Received
	Next
		The total number of alarm messages
	Advances to the next transponder.
		received by the central console from
	Bus X Point Y
		this transponder since the data was
	This field displays the current bus	last reset (using the Reset Transponder
		Troubles button).
	number and point number. The actual
	point number may be entered in the	Total Tests Received
	field to the right.	The total number of test messages
?
		received by the central console from
	Opens up the Select Point Screen.	this transponder since the data was
		last reset (using the Reset Transponder
+
		Troubles button).
	Advances to the next point.	Total Troubles Processed
-		The total number of trouble messages
	Returns to the previous point.	received by the central console from
	Unlimited Retries	the transponder and processed (see
		Total Troubles Shed) since the data was
	When this box is checked, the central
		last reset (using the Reset Transponder
	console continues trying to send	Troubles button).
	commands to a transponder even if the
		Total Troubles Shed
	commands are not being acknowledged.
	(Normally, the central console would	During certain rare occurrences, the
	cease after six retries and declare a	communication traffic on the
	communication failure.) When this	transponder links becomes excessive and
	screen is closed, the system reverts to	threatens to increase the system
	the normal six retries.	response time to tests and alarms. This
	3.3.10 Transponder Current Status	can happen if faults are reported at a
		very high rate. To avoid slow response
	Screen
		in such situations, the central console
	This screen, accessible from the Main
		may go into a load shedding mode in
	Menu under the Setup selection,	which it ceases to record and display
	provides a history of communications	Trouble Reports until the
	involving the transponder selected in	communications traffic subsides. The
	the transponder box. It also provides	Total Troubles Shed box indicates the
	several buttons, that can be used to	number of trouble messages that were
	diagnose problems with the transponder	not processed since the last reset
	and any of its receivers or alert	(using Reset Transponder Troubles
	units.	button).
	Figure 433: Transponder Current
Bosch Security Systems 6/12 38947D