Converged Enhanced Ethernet Command Reference 99
53-1001762-01
lacp system-priority 6
DRAFT: BROCADE CONFIDENTIAL
lacp system-priority
Sets the Link Aggregation Control Protocol (LACP) system priority.
Synopsis lacp system-priority value
no lacp system-priority
Operands value Specifies the value of the LACP system priority. The range of valid values is
1-65535.
Defaults The default system-priority value is 32768.
Command
Modes
Global configuration mode
Description Use this command to set the system priority of a local system. This determines which system is
responsible for resolving conflicts in the choice of aggregation groups. Use the no lacp
system-priority command to reset the system priority to the default value.
Note Lower numerical values have higher priorities.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To set the LACP system-priority to 68:
switch(config)#lacp system-priority 68
To clear the configured LACP system-priority:
switch(config)#no lacp system-priority
See Also none