Converged Enhanced Ethernet Command Reference 189
53-1001762-01
DRAFT: BROCADE CONFIDENTIAL
Chapter
12
QoS Commands

cee

Applies a CEE Provisioning map on an interface.
Synopsis cee name
no cee
Operands name Specifies the name of a previously created CEE map. Any existing CEE map
must be removed before a new one can be applied.
Defaults There is no CEE Provisioning applied on an interface.
Command
Modes
Interface configuration mode
Description Use this command to apply a CEE map on an interface. Use the no cee command to remove the
CEE Provisioning map.
Usage
Guidelines
The CEE map applied on an interface should exist on the switch.
Examples To apply a CEE map on an interface:
switch(conf-if-te-0/1)#cee demo
Because the switch does not allow applying a CEE map that does not exist, the following error
displays:
switch(conf-if-te-0/1)#cee test
% Error: Map does not exist
See Also cee-map