Brocade Communications Systems 53-1001762-01 seq (standard MAC ACLs)

122 Converged Enhanced Ethernet Command Reference

53-1001762-01

seq (standard MAC ACLs)

DRAFT: BROCADE CONFIDENTIAL

seq (standard MAC ACLs)

Inserts a rule anywhere in the MAC ACL.

Synopsis seq value {deny | permit} {any | host MAC _ACL| MAC_ACL} [count]

no seq value

Operands value Specifies the sequence number for the rule. The range of valid values is

0-65535.

permit or deny Specifies rules to permit or deny traffic.

any Specifies any source MAC address.

host MAC_ACL Specifies the source host MAC address for which to set permit or deny

conditions. Use the format HHHH.HHHH.HHHH.

MAC_ACL Specifies the source host MAC address for which to set permit or deny

conditions. Use the format HHHH.HHHH.HHHH.

count Enables the counting of the packets matching the rule.

Defaults By default, no MAC ACLs are configured.

Command

Modes

Feature Access Control List Configuration mode

Description Use this command to configure rules to match and permit or drop traffic based on source and

destination MAC address and protocol type. You can also enable counters for a specific rule. There

are 255 ACL counters supported per port group. Use the no seq value command to remove a rule

from the MAC ACL.

Usage

Guidelines

There are no usage guidelines for this command.

Example To create a rule in a MAC standard ACL to permit or to drop traffic from the source MAC address

0022.3333.4444 and to enable the counting of packets:

switch(conf-macl-std)#seq 100 deny 0022.3333.4444 count

switch(conf-macl-std)#seq 1000 permit 0022.3333.4444 count

To delete a filter rule in a MAC standard ACL:

switch(conf-macl-std)#no seq 100