62 Converged Enhanced Ethernet Command Reference
53-1001762-01
show interface
4
DRAFT: BROCADE CONFIDENTIAL
show interface
Synopsis show interface [port-channel number | tengigabitethernet slot/port | switchport ]
Operands port-channel number
Specifies to display the port-channel number. The range of valid values is
1-63.
tengigabitethernet
Specifies to display a specific 10 Gbps Ethernet interface.
slot Specifies to display a valid slot number.
port Specifies to display a valid port number.
switchport Specifies to display information for Layer 2 interfaces.
Defaults There are no default configurations for this command.
Command
Modes
EXEC mode
Description Use this command to display the detailed interface configuration and capabilities of all interfaces
or for a specific interface.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To display detailed information for 10 Gbps Ethernet interface 0/1:
switch#show interface tengigabitethernet 0/1
TenGigabitEthernet 0/1 is admin down, line protocol is down (admin down)
Hardware is Ethernet, address is 0005.1e76.1aa5
Current address is 0005.1e76.1aa5
Pluggable media present, Media type is sfp
Wavelength is 850 nm
Interface index (ifindex) is 67174401
MTU 2500 bytes
LineSpeed: 10000 Mbit, Duplex: Full
Flowcontrol rx: on, tx: on
Last clearing of show interface counters: 00:02:18
Queueing strategy: fifo
Receive Statistics:
0 packets, 0 bytes
Unicasts: 0, Multicasts: 0, Broadcasts: 0
64-byte pkts: 0, Over 64-byte pkts: 0, Over 127-byte pkts: 0
Over 255-byte pkts: 0, Over 511-byte pkts: 0, Over 1023-byte pkts: 0
Over 1518-byte pkts(Jumbo): 0
Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0
Errors: 0, Discards: 0
Transmit Statistics:
0 packets, 0 bytes
Unicasts: 0, Multicasts: 0, Broadcasts: 0
Underruns: 0
Errors: 0, Discards: 0
Rate info (interval 299 seconds):
Input 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Output 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate