50 Converged Enhanced Ethernet Command Reference
53-1001762-01
switchport converged
3
DRAFT: BROCADE CONFIDENTIAL
switchport converged
Adds or removes native and tagged VLANs on a Layer 2 interface.
Synopsis switchport converged { vlan vlan_id | allowed vlan {add vlan_id | all | except vlan_id | none |
remove vlan_id} }
no switchport converged
Operands vlan vlan_id Sets the default native VLAN for the Layer 2 interface.
allowed vlan Sets the VLANs that will transmit and receive through the Layer 2 interface.
add vlan_id Adds a VLAN to transmit and receive through the Layer2 interface. The range
of valid values is 2-3583.
all Allows all VLANs to transmit and receive through the Layer 2 interface.
except vlan_id Allows all VLANs except the VLAN ID to transmit and receive through the Layer
2 interface. The range of valid values is 2-3583.
none Allows no VLANs to transmit and receive through the Layer 2 interface.
remove vlan_id Removes a VLAN that transmits and receives through the Layer 2 interface.
The range of valid values is 2-3583.
Defaults The default native VLAN for a converged interface is 1.
Command
Modes
Interface configuration mode
Description Use this command to add or remove tagged VLANs on a Layer 2 interface.
Usage
Guidelines
There are no usage guidelines for this command.
Examples To set the native VLAN of 200 on an interface:
switch(conf-if-te-0/19)#switchport converged vlan 200
To set the tagged VLAN on an interface to 100:
switch(conf-if-te-0/19)#switchport converged allowed vlan add 100
To remove the tagged VLAN 100 from the interface:
switch(conf-if-te-0/19)#switchport converged allowed vlan remove 100
See Also show vlan brief, show interface switchport, switchport mode, switchport trunk