Converged Enhanced Ethernet Command Reference 55
53-1001762-01
vlan classifier rule 3
DRAFT: BROCADE CONFIDENTIAL
vlan classifier rule
Creates a VLAN classifier rule.
Synopsis vlan classifier rule rule_id [mac mac_address] [proto |arp| fcoe | fip] [encap ethv2 | nosnapllc |
snapllc]
no vlan classifier rule
Operands rule_id Specifies the VLAN identification rule. The range of valid values is 1-255.
mac Specifies the Media Access Control (MAC) list.
mac_address Specifies the MAC address-based VLAN classifier rule used to map to a
specific VLAN.
proto Specifies the protocol to use for the VLAN classifier rule.
arp Specifies to use the Address Resolution Protocol.
fcoe Specifies to use the Fibre Channel over Ethernet Protocol.
fip Specifies to use the FCoE Initialization Protocol.
encap Specifies to encapsulate the Ethernet frames sent for the VLAN classifier
rule.
ethv2 Specifies to use the Ethernet version 2 encapsulated frames.
nosnapllc Specifies to use the Ethernet version 2 non-SNA frames.
snapllc Specifies to use the Ethernet version 2 with SNA frames.
Defaults There are no default configurations for this command.
Command
Modes
Global configuration mode
Description Use this command to configure a VLAN classifier rule to dynamically classify Ethernet packets on
an untagged interface into VLANs. Use the no vlan classifier rule command to delete the VLAN
classifier rule specified by the rule_id.
Usage
Guidelines
VLAN classifiers can be created individually and can be managed separately. Up to 256 VLAN
classifiers can be provisioned. One or more VLAN classifiers can be grouped into a classifier group.
This classifier group can further be applied on an interface.
Examples To create an fcoe VLAN classifier rule:
switch(config)#vlan classifier rule 2 proto fcoe encap ethv2
To create a MAC-based VLAN classifier rule:
switch(config)#vlan classifier rule 2 mac 0000.0000.0100
See Also show vlan interface