2Converged Enhanced Ethernet Command Reference
53-1001762-01

CLI command modes

1
DRAFT: BROCADE CONFIDENTIAL
TABLE 2 Accessing the CEE CLI command modes
Command
mode
Prompt How to access the command mode Description
EXEC switch> Enter the cmsh command at the
Fabric OS prompt after you have
logged in as an appropriate user.
Display running system information
and set terminal line parameters.
Privileged
EXEC
switch# From the EXEC mode, enter the
enable command.
This is the administrative mode
which also includes EXEC mode
commands and allows you to display
and change system parameters.
Global
configuration
switch(config)# From the EXEC mode, enter the
configure terminal EXEC command.
Configure features that affect the
entire switch.
Interface
configuration
Port-channel:
switch (conf-if-po-63)#
10-Gigabit Ethernet (CEE port):
switch (conf-if-te-0/1)#
VLAN:
switch (conf-if-vl-1)#
From the global configuration mode,
specify an interface by entering one
of the following interface types:
•interface port-channel
•interface tengigabitethernet
•interface vlan
Access and configure individual
interfaces.
Protocol
configuration
LLDP:
switch (conf-lldp)#
Spanning-tree:
switch (conf-mstp)#
switch (conf-rstp)#
switch (conf-stp)#
From the global configuration mode,
specify a protocol by entering one of
the following protocol types:
•protocol lldp
•protocol spanning-tree mstp
•protocol spanning-tree rstp
•protocol spanning-tree stp
Access and configure protocols.
Feature
configuration
CEE map:
switch (config-ceemap)#
Standard ACL:
switch (conf-macl-std)#
Extended ACL:
switch (conf-macl-ext)#
From the global configuration mode,
specify a CEE feature by entering
one of the following feature names:
•cee-map
•mac access-list
Access and configure CEE features.
Console and
VTY (line)
configuration
switch (config-line)# From the global configuration mode,
configure a terminal connected
through the console port by entering
the line console command.
Configure a terminal connected
through a Telnet session by entering
the line vty command.
Configure a terminal connected
through the console port or a
terminal connected through a Telnet
session.