Brother MFC-795CW 168

Error Message	Cause	Action
Cannot Detect	You installed a new ink cartridge	Take out the new ink cartridge and
	too quickly and the machine did	re-install it slowly until it clicks.
	not detect it.

	If you are not using genuine	Use a new Genuine Brother Innobella™
	Brother Innobella™ ink the	Ink Cartridge. If the error is not cleared, call
	machine may not detect the ink	Brother Customer Service.
	cartridge.

	An ink cartridge is not installed	Take out the new ink cartridge and re-
	properly.	install it slowly until it clicks.

Cannot Print	One or more of the ink cartridges	Replace the ink cartridges. (See Replacing
	have reached the end of their life.	the ink cartridges on page 162.)
	The machine will stop all print
	operations. While memory is
	available, black & white faxes will
	be stored in the memory. If a
	sending machine has a color fax,
	the machine's ‘handshake’ will
	ask that the fax be sent as black &
	white. If the sending machine has
	the ability to convert it, the color
	fax will be stored in the memory
	as a black & white fax.

Comm.Error	Poor telephone line quality	Send the fax again or connect the machine
	caused a communication error.	to another telephone line. If the problem
		continues, call the telephone company and
		ask them to check your telephone line.

Connection Fail	You tried to poll a fax machine	Check the other fax machine's polling
	that is not in Polled Waiting mode.	setup.
Cover is Open.	The scanner cover is not closed	Lift the scanner cover and then close it
	completely.	again.
	The ink cartridge cover is not	Firmly close the ink cartridge cover until it
	completely closed.	clicks.

Data Remaining	Print data is left in the machine's	Press Stop/Exit. The machine will cancel
	memory.	the job and clear it from the memory. Try to
		print again.

Disconnected	The other person or other	Try to send or receive again.
	person's fax machine stopped the
	call.

Document Jam	The document was not inserted or	See Using the ADF on page 21.
	fed properly, or the document	See Document jam on page 159.
	scanned from the ADF was too	See Document jam on page 159.
	scanned from the ADF was too
	long.

High Temperature	The print head is too warm.	Allow the machine to cool down.
Hub is Unusable.	A Hub or USB Flash memory	A Hub or USB Flash memory drive with
	drive with Hub has been	Hub are not supported. Unplug the device
	connected to the USB direct	from the USB direct interface.
	interface.

152

Contents

Page http://www.brother.com/registration http://solutions.brother.com http://www.brothermall.com http://www.brother.ca Page Brother® One-YearLimited Warranty and Replacement Service (USA Only) Page BROTHER MULTIFUNCTION CENTER / FAX MACHINE LIMITED WARRANTY General Information Loading paper and documents General setup Security features Sending a Fax Receiving a Fax Telephone Services and External devices Dialing and storing numbers Message Center Printing Reports Polling Making copies PhotoCapture Center®: Printing photos from a memory card or USB Flash memory drive Printing photos from a camera Software and Network features Safety and Legal Troubleshooting and Routine Maintenance Menu and Features Specifications Glossary Index General General Information Loading paper and documents General setup Security features Symbols and conventions used in the documentation WARNING CAUTION IMPORTANT Viewing Documentation How to find Scanning instructions How to find Network setup instructions Viewing Documentation (Macintosh) Page Page Page LCD screen Basic Operations Page Page Loading envelopes and postcards About envelopes Loading envelopes and postcards Loading photo paper Removing small printouts from the machine Printable area Recommended print media Brother paper Handling and using print media Paper capacity of the output paper tray cover Choosing the right print media Paper type and size for each operation Paper weight, thickness and capacity Using the ADF Recommended environment Document Sizes Supported How to load documents Using the scanner glass Scannable area Turning the machine off Turning the machine on Paper Type Paper Size Ring Volume Setting the Ring Volume from the menu Beeper Volume Speaker Volume Handset Volume Choosing the Handset Volume (for Volume Amplify) WARNING Setting Volume Amplify Page Setting the backlight brightness Setting the Dim Timer for the backlight Setting and changing the memory security password Setting a password for the first time Changing your memory security password Turning the memory security on/off Turning on the memory security lock Turning off the memory security Page Fax Sending a Fax Receiving a Fax Telephone Services and External devices Dialing and storing numbers Faxing from the ADF Faxing from the scanner glass Faxing A4 size documents from the scanner glass Color fax transmission How to preview an outgoing fax (Black & White only) Canceling a fax in progress Page Canceling a Broadcast in progress Sending faxes using multiple settings Changing fax resolution Dual Access (Black & White only) Real Time Transmission Overseas Mode Delayed Faxing (Black & White only) Delayed Batch Transmission (Black & White only) Checking and canceling waiting jobs Restoring all fax settings to the factory settings Sending a fax manually Sending a fax at the end of a conversation Out of Memory message Choose the correct Receive Mode Page Fax Only Fax/Tel Manual Message Center (MC) Ring Delay F/T Ring Time (Fax/Tel mode only) Easy Receive If Easy Receive is On: If Easy Receive is Semi: If Easy Receive is Off: Fax Forwarding Paging Fax Storage PC Fax Receive (Windows® only) Changing the destination PC Turning off Memory Receive Operations Changing Memory Receive Operations How to preview a received fax Setting Fax Preview Using Fax Preview How to print a fax How to print all faxes in the list How to delete all faxes in the list Turning off Fax Preview Printing a reduced incoming fax Receiving a fax at the end of a conversation Receiving faxes into memory when the paper tray is empty Printing a fax from the memory Setting a Remote Access Code Using your Remote Access Code Remote Fax commands Retrieving fax messages Changing your Fax Forwarding number Making a telephone call Answering calls with the Speaker Phone Hold Tone or Pulse (Canada only) Fax/Tel mode Voice Mail Distinctive Ring What does your telephone company's ‘Distinctive Ring’ do What does Brother's ‘Distinctive Ring’ do Do you have Voice Mail Before you choose the ring pattern to register Registering the Distinctive Ring pattern Turning off Distinctive Ring Caller ID Setting up your area code (USA only) Connections Recording outgoing message (OGM) on an external TAD Special line considerations Roll over telephone lines Two-linetelephone system Converting telephone wall outlets Installing machine, external two-lineTAD and two-linetelephone Multi-lineconnections (PBX) Connecting an external or extension telephone Using external and extension telephones Using extension telephones Using an external telephone (connected to the EXT. jack of the machine) If you answer a call and no one is on the line: Using a non-Brothercordless external telephone Using remote codes Fax Receive code Telephone Answer Code Changing the remote codes Page Manual dialing Speed Dialing Fax Redial Outgoing Call Caller ID history Storing a pause Storing Speed Dial numbers Storing Speed Dial numbers from Outgoing Calls Storing Speed Dial numbers from the Caller ID history Changing Speed Dial names or numbers Setting up groups for broadcasting Changing a Group name Deleting a Group Deleting a number from a Group Dialing Access codes and credit card numbers Setting up the Message Center Outgoing message (OGM) Recording your OGM Listening to your OGM Erasing your OGM Fax/Tel OGM (Announcement) Activating Message Center mode Message indicator Playing incoming messages individually Playing all incoming messages Erasing incoming messages To erase incoming messages individually To erase all of your messages Recording a conversation Playing recorded conversations individually Playing all recorded conversations Erasing recorded conversations To erase recorded conversations individually To erase all of your recorded conversations Setting the maximum time for incoming messages Setting toll saver ICM Recording Monitor Transmission Verification Report Fax Journal (activity report) How to print a report Setup to receive polling Sequential polling (Black & White only) Canceling a Sequential Polling Job Set up for polled transmit Copy Making copies Entering Copy mode Making a single copy Making multiple copies Stop copying Changing copy quality Enlarging or reducing the image copied Making N in 1 copies or a poster (Page Layout) Page Sorting copies using the ADF Adjusting Brightness and Ink Save Mode Paper Options Paper Size Book Copy Watermark Copy Setting your favorites Retrieving your favorite setting Rename your favorite setting Direct Printing PhotoCapture Center®: Printing photos from a memory card or USB Flash memory drive Printing photos from a camera Printing from a memory card or USB Flash memory drive without a PC Scanning to a memory card or USB Flash memory drive without a PC Using PhotoCapture Center® from your computer Using a memory card or USB Flash memory drive Memory cards, USB Flash memory drive and folder structure Page Entering PhotoCapture mode View Photos Print Index (Thumbnails) Printing Photos Enhance Photos Page Page Print Quality Paper options Paper and print size Adjusting Brightness Contrast and Color Color Enhancement (True2Life®) Cropping Borderless printing Print Date Restoring all settings to the factory settings Entering Scan mode How to scan to a memory card or USB Flash memory drive Auto Crop How to set a new default How to reset to the factory settings PictBridge requirements Setting your digital camera Printing Images Page Page Page Software Software and Network features Page Appendixes Safety and Legal Troubleshooting and Routine Maintenance Menu and Features Specifications CAUTION Page Page Page Page Page Important safety instructions Page Page Federal Communications Commission (FCC) Declaration of Conformity (USA only) Industry Canada Compliance Statement (Canada only) LAN connection International ENERGY STAR® Qualification Statement Page Page If you are having difficulty with your machine Page Printing Received Faxes Telephone Line or Connections Receiving Faxes Receiving Faxes (continued) Sending Faxes Handling Incoming Calls Copying Difficulties Scanning Difficulties Software Difficulties PhotoCapture Center® Difficulties Network Difficulties Network Difficulties (continued) Touchscreen Difficulties Dial Tone Telephone line interference Page Page Page Page Page Page Error animation Transferring your faxes or Fax Journal report Transferring faxes to another fax machine Transferring faxes to your PC Transferring Fax Journal report to another fax machine Document jam Document is jammed in the top of the ADF unit Document is jammed inside the ADF unit Printer jam or paper jam Page Replacing the ink cartridges Page Cleaning the outside of the machine Cleaning the scanner Cleaning the machine’s printer platen Cleaning the paper pick-uprollers Cleaning the print head Checking the print quality Checking the print alignment Checking the ink volume Uninstalling and installing the handset and handset cradle Uninstalling the handset and handset cradle Installing the handset and handset cradle Checking the serial number Reset functions How to reset the machine Page Page Menu table Memory storage Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Entering Text Inserting spaces Making corrections Repeating letters Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Wireless one-pushconfiguration Page Page Page Page Page Page Page Page Page Page EQUIPMENT ATTACHMENT LIMITATIONS Visit us on the World Wide Web http://www.brother.com