Dual Access
You can dial a number, and begin scanning the fax into memory— even when the MFC is receiving, sending or printing a fax from memory. The LCD shows the new job number.
If you get a Out Of Memory message while scanning the first page of a fax, press Stop/Exit to cancel scanning. If you get a Out Of Memory message while scanning a subsequent page, you can press Start to send the pages scanned so far, or press Stop/Exit to cancel the operation.
1 If it is not illuminated in green, press (Fax). Place the original face up in the ADF, or face down on the scanner glass.
2 Enter the fax number.
3 Press Start to send the fax.
The MFC starts scanning the first page and the LCD shows the job number (#XXX) of the fax. You can repeat Steps 1 to 3 for the next fax.
If you are using the scanner glass, go to Step 5.
4 To send a single page, press 2 (or press Start again).
The MFC starts sending the original.
To send more than one page, press 1 and go to Step 5.
5 Place the next page on the scanner glass. Press Set.
The MFC starts scanning, and then returns to Step 4. (Repeat Steps 4 and 5 for each additional page). To send the next fax, go to Step 1.
SETUP SEND 6 - 9