9 Printing reports
MFC settings and activity
You need to set up the Transmission Verification Report and Activity Report Interval in the menu table.
Press Menu, 2, 4, 1. | 24.Setup Reports | |
1.Transmission | ||
Press Menu, 2, 4, 2. | ||
2.Act.Interval | ||
| Select ▲▼ & Set |
Customizing the
Transmission Verification Report
You can use the Transmission Report as proof that you sent a fax. This report lists the time and date of transmission and whether the transmission was successful (OK). If you select On or On+Image, the report will print for every fax you send.
If you send a lot of faxes to the same place, you may need more than the job numbers to know which faxes you must send again. Selecting On+Image or Off+Image will print a section of the fax’s first page on the report to help you remember.
When the feature is Off, the Report will only print it there is a transmission error. (NG).
1 | Press Menu, 2, 4, 1. | 24.Setup Reports | |||
2 | Press | or | to select Off, |
| 1.Transmission |
▲ | Off | ||||
| Off+Image, ON or On+Image. | ▼ | Off+Image | ||
| Press Set. |
|
| Select ▲▼ & Set | |
3 Press Stop/Exit.
PRINTING REPORTS 9 - 1