4 Plug the NC-9100h into connector P1 located on the main board as shown in the illustration (press firmly) and secure the NC-9100h with the two screws.

5 Put the metal shield plate back on and secure it with the two screws.

6

7

8

9

Put the side cover back on.

Reconnect the telephone line cord.

Reconnect any additional interface cables that you removed.

Reconnect the power cable and then turn on the MFC power switch.

10 Press the Test switch and print a network configuration page. (See TEST SWITCH on page 23-9.)

OPTIONAL ACCESSORIES 23 - 7