Arranging Embroidery Designs (Layout & Editing)

Creating the design

1.The Design Page appears on the screen as shown below.

a

b

c

b Memo:

Area a: Embroidering area when the multi- position hoop is installed at the top installation position.

Area b: Embroidering area when the multi- position hoop is installed at the middle installation position.

Area c: Embroidering area when the multi- position hoop is installed at the bottom installation position.

The dotted lines separate each area.

2.Create the design, making sure that it meets the following conditions.

The size of one pattern must be no larger than 100 100 mm (or 130 180 mm).

a

1

4

b

 

2 3

c

Each pattern must completely fit within a single area (a, b, or c).

1:The position of this pattern is correct since it fits completely within area a.

2:The position of this pattern is correct since it fits completely within either area b or area c.

3:The size of this pattern is acceptable, but its position must be corrected since it does not fit completely within any of the areas.

(It will be necessary to correct the position in order to fit in either b or c.)

4:This pattern must be corrected since it is too large.

(It will be necessary to correct the position and size in order to fit in either a, b, or c.)

a Note:

If a pattern does not meet the conditions mentioned above, a warning will appear when continuing to the next step.

Optimizing hoop changes

With the Optimize hoop change function, the sewing order of patterns in a Design Page for multi-position hoops is automatically optimized, therefore reducing the risk of the embroidery being sewn incorrectly or the fabric not feeding evenly when the hoop position is changed too often.

1.Click Sew, then Optimize hoop change.

185

Page 191
Image 191
Brother PE-DESIGN V7 Creating the design, Optimizing hoop changes, Design Page appears on the screen as shown below