Brother PE-DESIGN V7 instruction manual 220

Manually Creating Embroidery Patterns From Images (Design Center)

Fill stitch

	Sets underlay stitching on or off. Try to use underlay stitching for wide areas, in order to
	prevent shrinking during stitching.
	On: Underlay stitching will be sewn.
	Off: Underlay stitching will not be sewn.
Under sewing	Default: Off	Single:		Double:
	[Type] Specifies the type of underlay stitching sewn.
	Single: Sews perpendicular to the specified sewing direction.
	Double: Sews a pattern at a 45° angle to the specified sewing
	direction.
	Sets the number of lines per millimeter.
Density	Range: 1.0 – 7.0 lines per mm (25 – 178 lines per inch)
	Default: 4.5 lines per mm (114 lines per inch)
	Sets the density gradation setting on or off.
	Available when the type of sewing direction is set to Constant.
Gradation	Click Pattern to set the gradation pattern and its density.
	Default: Off
	For details on this attribute, refer to“Creating a gradation” on page 225.
	[Type] Specifies the type of sewing direction.
	Constant: Sews at a fixed angle. The angle is specified by the angle setting.
	Variable: Varies the sewing direction according to the region being sewn.
Direction	[Angle] Specifies the sewing angle.	135° 90° 45°
	Available only when the sewing direction type is
		180°			0°
	set to Constant.
	Range: 0 – 359 degrees	225°	315°
	Default: 45 degrees
			270°

Specifies the shape of stitching on the edges.

Stitch Type	Available settings:	,
	Default:
	Sets half stitching on or off.
	Available when the type of sewing direction is set to Vari-		On:
	able.
Half Stitch
	If one side of the fill stitching is dense, a half stitch could be
			Off:
	sewn automatically to provide a more even density.
	Default: Off
	Sets the running path of the stitching.			Inside of region:
	Available when the type of sewing direction is set to Constant.
	Available settings:
	• Inside of region (shortest route)			Along outline:
Running Stitch Path	• Along outline (along the inner side)
	• Onto outline (on the outline)
	The inside of region setting is available only when the Gradation			Onto outline:
	check box is cleared.
	Default: Inside of region
	Sets the pitch of the stitching.			Step pitch:
Step Pitch	Range: 1.0 – 10.0 mm (0.04 – 0.39 inch)
	Default: 4.0 mm (0.16 inch)
	Sets the spacial frequency steps.			30%	0%
	Range: 0–99%
Frequency
	Default: 30%
	Lengthens the sewing region in the stitch pattern’s sewing direction to prevent pattern shrink-
Pull Compensation	age during sewing.
	Range: 0.0 – 2.0 mm (0.00 – 0.08 inch)
	Default: 0.0 mm (0.00 inch)

220