Setting up
11
6 Charging the handset
The handset is powered by a rechargeable
NiCad battery. The charger uses a fast charge
system. For example, 10 minutes of charging
will give about 10 minutes of talk time. When
fully charged the battery should give up to 5
hours talk time and up to 50 hours standby.
When the handset is not in the charger, the
charging icon indicates the current level of
charge in the battery - 4 dots means the
handset is fully charged and 1 dot means the
charge is low.
ab
eg 50% charge
5 Inserting the output paper
1Open the sheet feeder flap by lifting it up at
the side.
2Lift the paper support bar.
3Insert up to 30 sheets of paper between
the paper guides and adjust the left paper guide
(a) to the width of the paper. Press the clip (b)
and allow the paper to fall down into position.
IMPORTANT
The new handset may not be charged. It takes up to
12 hours to charge completely.
IMPORTANT
Use A4 paper of 80gsm. The paper should be non-
transparent and not torn or crumpled.
IMPORTANT
It is important to have the document support bar
raised during printing to prevent paper feeding back
into the machine.
* Keep the document
support bar raised
when printing