Technical information
Choosing a position
Your DECTfax Plus should be kept clear of dust, moisture, high temperature and vibration and should not be exposed to direct sunlight. Don’t install it close to radiators or
WARNING
The apparatus is only designed to be operated in a normal office or domestic environment where the relative humidity does not exceed 60%. It should not be used in bathrooms or near water.
Approval number
BABT Certificate Number/Approval Number for the DECTfax Plus 606594 APPROVED for connection to telecommunication system specified in the instructions for use subject to the conditions set out in them.
Approval for use
This apparatus has been approved for the use of the following facilities:
Terminal and subscriber identifier Transmission status report (send report only) Manual mode (associated telephone set)
Fax switch
Polling RX (to poll a document from a distant fax) Polling TX (prepare a document to be polled) Delayed transmission – Time recorder and logs Modem fax up to 14400 bps
Auto calling
Automatic redial (5 times, 5 minutes intervals) Facsimile transmission and reception
Calls progressing mode Series connection (TAM) Automatic document feeder 16 shades of grey
DECT TAD facility
Any other usage will invalidate the approval of the apparatus if as a result, it then ceases to conform to the standards against which approval was granted.
You may connect it –
•To direct exchange lines.
•To extensions with new plug and socket arrangements provided with these direct exchange lines.
•To compatible switchboards.
You may NOT connect it –
• To shared service (party) lines.
The connection to the telecommunication system must be unplugged before the earth is disconnected. The connection to the telecommunication system must not be hardwired.
This apparatus may be used on telecommunications systems employing loop disconnect or MF signalling.
Ringing delay
The maximum number of rings before automatic answering is 9.
How many phones you can have
Your exchange line provides only a small current to make your telephone ring. Although you may have any number of sockets it is important to limit the number of telephones and other items of apparatus connected to the line by these sockets. This ensures that each telephone will receive enough current to ring.
Every telephone or item of apparatus has a Ringer Equivalence Number (REN). In most cases a standard line should provide enough current for two or more telephones or items of apparatus, if the REN’s add up to no more than 4.
DECTfax Plus has a REN of 1. Any telephone provided by BT may be assumed to have a REN of 1 unless otherwise stated on the base. Even where the number of telephones has been limited, there is no guarantee that the different types of telephone on the same line will ring.
54
