Chapter 5: Local Management
5.10SWITCH CONFIGURATION SCREEN
NOTE |
The Switch Configuration screen is not available if the operational mode of the device is set to SECURE FAST VLAN. This screen may only be used when the device is configured to operate as an 802.1D or 802.1Q switch.
The Switch Configuration screen, Figure
To access the Switch Configuration screen from the Device Configuration Menu screen, use the arrow keys to highlight the SWITCH CONFIGURATION menu item and press ENTER. The Switch Configuration screen displays showing up to 7 ports, depending on if there are Fast Ethernet Interface Modules and an HSIM installed in the device.
Event Message Line
|
|
|
| |
| Switch Configuration |
|
| |
Device Name: | Firmware Revision: | XX.XX.XX | ||
|
| BOOTPROM Revision: XX.XX.XX | ||
Switch Address: | Type of STA: |
|
| |
[DEC] |
| |||
Number of Ports: | 7 | Age Time (sec): | 300 |
|
|
|
| ||
Port # | MAC Address | State | Status | |
1 | learning | [ENABLED] | ||
2 | listening | [DISABLED] | ||
3 | standby | [ENABLED] | ||
4 | learning | [DISABLED] | ||
5 | listening | [ENABLED] | ||
6 | standby | [DISABLED] | ||
7 | listening | [ENABLED] | ||
SAVE | EXIT |
| RETURN | |
Figure 5-17 Switch Configuration Screen
|
