Cabletron Systems 2E43-51R manual Enabling/Disabling IP Fragmentation

Chapter 5: Local Management

WARNING

YOU HAVE ELECTED TO CLEAR NVRAM. THIS WILL CLEAR ALL SYSTEM DEFAULTS INCLUDING BUT NOT LIMITED TO IP ADDRESS, INTERFACE CONFIGURATION, AND COM PORT CONFIGURATION, THEN RESET THE BOARD.

ARE YOU SURE YOU WANT TO CLEAR NVRAM?

YES NO

174251

Figure 5-14 Clear NVRAM Warning Screen

5.Select YES and the message “CLEARING NVRAM. REBOOT IN PROGRESS...” displays.

6.The 2E43-51 clears NVRAM and reboots. All user-entered parameters default to factory default settings.

5.7.12 Enabling/Disabling IP Fragmentation

To enable or disable IP Fragmentation, proceed as follows:

If the 2E43-51 is being bridged to an FDDI ring (for example,

!via an optional HSIM-F6), enable IP Fragmentation. If it is

CAUTION	disabled, all FDDI frames that exceed the maximum Ethernet
	frame size are discarded.

1.Use the arrow keys to highlight the IP Fragmentation field.

2.Press the SPACE bar to choose either ENABLED or DISABLED.

3.Use the arrow keys to highlight the SAVE command.

4.Press ENTER. The message “SAVED OK” displays at the top of the screen.

5-30 2E43-51/2E43-51R User’s Guide