Chapter 5: Local Management
Event Message Line |
|
|
|
| |
|
|
|
|
| |
|
| Port Level Security Configuration |
|
| |
Module Type: |
| Firmware Revision: | XX.XX.XX | ||
|
|
| BOOTPROM Revision: XX.XX.XX | ||
Po rt | State | Lock/Learn | Action On Intruder |
| Secure Address |
1 | [Secure] | [LockOnNext] | [DisablePort] [SendTrap] |
|
|
2 | [NonSecure] | [Unlocked] |
| ||
3 | [Secure] | [LockedOnAddr] | [DisablePort] [SendTrap] | [xx.xx.xx.xx.xx.xx] | |
4 | [NonSecure] | [Unlocked] |
| ||
5 | [NonSecure] | [Unlocked] |
| ||
6 | [NonSecure] | [Unlocked] |
| ||
7 | [NonSecure] | [Unlocked] |
| ||
8 | [NonSecure] | [Unlocked] |
| ||
9 | [NonSecure] | [Unlocked] |
| ||
10 | [NonSecure] | [Unlocked] |
| ||
11 | [NonSecure] | [Unlocked] |
| ||
12 | [NonSecure] | [Unlocked] |
| ||
INTERFACE #: [1] | SAVE | EXIT |
| RETURN | |
2251_113
Figure 5-27 Port Level Security Configuration Screen
The following section defines the fields on the Port Level Security Configuration screen.
Port (Read-only)
Indicates the repeater port on the ENET connector (ENET 1 through 4) selected in the INTERFACE # field. Refer to Table
Table 5-5 ENET/Repeater Port Relationship
ENET 1 | = Repeater ports 1 – 12 | ENET 3 = Repeater ports 25 – 36 |
|
|
|
ENET 2 | = Repeater ports 13 – 24 | ENET 4 = Repeater ports 37 – 48 |
|
|
|
State (Selectable)
Used to select the state of security for frames received by any port on the connector. The states are as follows:
•Secure – Allows the ports on the connector to receive only those frames with the address as determined by the selection in the Lock/Learn field.
|
