Chapter 5: Local Management
Learning: The switch is learning the addresses on this interface. The switch enters the learning state when the Transparent Database is created (during
Forwarding: The switch is operating and this interface is forwarding traffic.
Blocking: This interface will not forward any traffic through the switch because a loop condition has been detected by the STA.
Status (Toggle)
Allows the user to disable or enable a port by setting the status of the listed interface to either ENABLED or DISABLED. To set the port status, refer to Section 5.10.3.
5.10.1 Setting the STA
The Spanning Tree Algorithm (STA) setting allows the user to set the method that the switches use to decide which is the controller (Root) switch when two or more switches are in parallel. The available selections are IEEE, DEC, and NONE.
To set the STA, proceed as follows:
1.Use the arrow keys to highlight the Type of STA field.
2.Use the SPACE bar to step to the appropriate setting of IEEE, DEC, or NONE.
3.Use the arrow keys to highlight the SAVE command at the bottom of the screen.
4.Press ENTER. The message “SAVED OK” displays.
5.10.2 Setting the Age Time Field
To set the Age Time, proceed as follows:
1.Use the arrow keys to highlight the Age Time field.
2.Type in the desired Age Time in increments of 10. The available Age Time range is 10 to 1,000,000 seconds with the default value being 300 seconds.
|
