Installing the Switch | Switch Installation and Setup |
••Check the power label on the back of the switch to make sure that the required line voltage corresponds to the line voltage you are using.
T• Insert the supplied power cord into the 3-prong power receptacle on the back of the switch.
Q• +•Ö}ÊÍ…iÊ«œÝiÀÊVœÀ`ʈ˜ÍœÊ>Ê>˜Ê"+ÊœÖÍ•iÍÊÍ…>ÍÊ>VVi«ÍÃÊφ«Àœ˜}Ê«•Ö}ð
%"¤›apm The SmartCell ZX-250 switch must be attached to a grounded 3-prong outlet. Ensure that the outlet has a proper safety ground. Do not defeat the safety ground by using a 2-prong adapter or extension cord. Doing so voids the new product warranty.
2p›F For information on power consumption, see Appendix B, “Specifications.”
Rack installation is complete. Proceed to the section: “Switch Configuration.”
2.4.3Rack Installation for ZX-250r
You can install the SmartCell ZX-250r switch in a standard 19-inch mounting rack by using the provided side-mount brackets. Each switch occupies 4.5 inches of rack space or between two and three “rack mounting units.” This installation results in an air gap of approximately 0.5 inches vertically between switches. There must be an air gap of at least four (4) inches on either side of the rack for proper air flow to the cooling fans. (ZX-250r chassis are 17.5 inches wide by 20.5 inches deep.)
>"•mamV If you perform the following procedure with the SmartCell ZX-250r power supplies installed, make certain that the they are locked in place.
NEVER lift or move the SmartCell ZX-250r by its power supply handles.
s• With the SmartCell ZX-250r switch resting on a flat surface, use a Phillips screwdriver to remove two (2) #6-32 screws from each side of the switch chassis (see Figure 2-7). These screws are replaced by screws included with the SmartCell ZX-250r rack mount components.
¢• Mount the brackets on both sides of the front of the switch (see Figure 2-7). Attach each bracket to the side of the chassis using two (2) #8-32 x 0.38 flat-head screws and two (2) #6-32 x 0.38 flat-head screws.
2-8 SmartCell ZX-250 User Guide
