PVC Connections | Switch Administration |
••Use the set portconfig command to reconfigure a port to use the new values for VPI and VCI. For example, to set up a PVC on port A1 using the new VPI/VCI bit ranges (3/9), enter
SmartCell ZX # set portconfig a1 |
|
PortAdminStatus(up) | : |
IlmiAdminStatus(enable) | : |
IlmiAddressRegistration(enable) | : |
IlmiConnectivity(enable) | : |
SigType(autoConfig) | : |
SigRole(other) | : |
InterfaceType(private) | : |
MaxVpiBits(0) | : 3 |
MaxVciBits(12) | : 9 |
MaxSvcVpi(7) | : |
MinSvcVci(32) | : |
MaxVccs(4096) | : |
SmartCell ZX # |
|
T• Use show portconfig to see the change to port A1.
SmartCell ZX # show portconfig a1
==================================================
Port: A1
Parameter | Configured | Current | |
Sig Type | autoConfig | pnni10 | |
Sig Role | other | symmetric | |
Interface Type | private | private | |
Max vpi bits | 3 | 0 | <VPI on port A1 can now be any |
Max vci bits | 9 | 9 | <VCI on port A1 can now be any |
Max SVC vpci | 7 | 0 |
|
Min SVC vci | 32 | 32 |
|
Max Vccs | 4096 | 4096 |
|
Other parameters
Port Admin Status | UP |
Ilmi Admin Status | Enabled AddressRegistration Connectivity |
Oper State | UP |
Trans Type | |
Media Type | MMF (S) |
Bandwidth | 155 MB |
SmartCell ZX # |
|
PVCs can be configured for port A1 using VPI values from 0 to 7 and VCI values from 0 to 511.
2p›F Do not set the VCI part of the VCCMask to fewer than 5 bits.
2p›F Do not change the VCCMask for the CPU port (B4).
