
Switch Administration
Image is downloaded into boot PROM by df b chpi sets which is the default boot image
Upgrading and Changing Software
POST is downloaded into flash RAM by df p
ponf turns POST on and off.
initial routines
boot image 0 boot image 1
MAC addresses
configuration storage
boot PROM
Cleared by clfs
Switch software is downloaded to flash RAM by df s
POST diagnostics
SmartCell
go runs switch software in
DRAM
flash RAM
Figure 4-4 Memory locations affected by the boot load commands
4.7.3Upgrading Boot Load Software
Two images of the boot load software reside in flash RAM. The two images are identified as boot load image 0 and boot load image 1. Both boot load images can be upgraded by using a TFTP/Bootp server. However, an upgrade is always written over the boot load image that is not currently running. This insures that if a boot load upgrade fails, there is still one good boot load image to fall back on.
Follow the steps below to upgrade the switch boot load software. s• Set up the TFTP/Bootp server software on a workstation.
¢• Connect both the TFTP/Bootp server and the SmartCell
••Connect a dumb terminal (or PC running terminal emulation software) to the SmartCell
T• Copy the SmartCell
SmartCell