Cabletron Systems ZX-250 ATM Routing, Creating an Iisp Route, SmartCell ZX # show netprefix b2

ATM Routing Switch Administration

Once you enter the backup command, the switch stores the IP address of the TFTP server, the path, and the backup file name. The next time the backup or restore commands are entered, these values are presented as the default IP address and path. For example, when the restore command is entered, the following appears:

SmartCell ZX# restore switch

ServerIP(90.1.1.100) :

Path(/back_dir/config-1) :

SmartCell ZX #

Backup file is valid.

Restoring a backup file will completely replace any data stored in the flash. Are you sure this is what you want to do?

Confirm(y/n)?: y

SmartCell ZX #

2p›F The switch must be rebooted for the restore to take effect.

4.2ATM ROUTING

The SmartCell ZX-250 default routing protocol is PNNI version 1.0. PNNI provides automatic and dynamic connectivity among all PNNI nodes within the same peer group. For purposes of interoperability, however, the SmartCell ZX-250 also supports these additional ATM routing protocols:

UIISP — Use to connect with devices that do not support PNNI

UUNI — Use to connect end stations (also to connect devices whose implementation of ILMI is incompatible with the SmartCell ZX-250)

2p›F Both IISP and UNI routes are created and modified using the ATMRoute command. The proper route type is determined by the SmartCell ZX-250 through interface signaling information.

4.2.1Creating an IISP Route

Use the add ATMRoute command to create an IISP route that links the SmartCell ZX-250 to a device that supports only IISP routing. For example,

s• Physically connect port b2 of the SmartCell ZX-250 to the IISP device.

¢• Enter show NetPrefix to determine the net prefix of port b2 on the SmartCell ZX-250:

SmartCell ZX # show netprefix b2

Port NetPrefix

==============================================================================

B2 39:00:00:00:00:00:00:00:00:00:14:41:80

SmartCell ZX #

••Determine the address of the IISP device. (For this example, this could be a port address, we use 52:00:00:00:00:00:00:00:00:00:14:51:80)

4-2 SmartCell ZX-250 User Guide