Agent Support | Managing the SmartCell ZX-250 |
UatmIfAdminAddrTable
UatmVclAddrBindTable
UatmAddrVclTable
UatmVplStatTable
UatmVplLogicalPortTable
UatmVclGenTable
UatmfMyOsiNmNsapAddress
UatmfVpcTable
UlecRouteDescrTable
UleRDArpTable
C.2 MANAGING THE SMARTCELL ZX-250
Your SmartCell ZX-250 must be IP reachable by the NMS before it can be managed. The default connection between the SmartCell ZX-250 and the NMS is the SmartCell ZX-250 Ethernet interface. Use the show SwitchConfig command to find the IP address of the SmartCell ZX-250. An NMS can use this IP address to reach the SmartCell ZX-250 through Ethernet. An NMS can also manage the SmartCell ZX-250 through one of its ATM ports if the SmartCell ZX-250 has a client connection into a VLAN or emulated LAN.
Note that the SmartCell ZX-250 itself, is not reachable through ATM until a client for the switch is created and participates as a member of a VLAN or ELAN. Your NMS uses that switch client’s address to access and manage the switch.
To create a client for the switch, use the add IPATMClient command for VLANs and add LANEClient for emulated LANs.
Use the set MyNmAddr command to tell the SmartCell ZX-250 which interface to use when communicating with your NMS. For detailed information about these commands, see the SmartCell 6A000/ZX-250 Reference Manual.
C.2.1 Console Commands that Affect the Agent
The following is a list of the console commands that affect the operation of the SmartCell ZX-250 SNMP agent. For detailed descriptions of these commands, see the SmartCell 6A000/ZX-250 Reference Manual.
UCommunity: Sets the community strings for the SmartCell ZX-250
UTrapCommunity: Specifies the NMS to which traps are sent
UMyNMAddr: Specifies the IP address through which the switch is managed
UTrustedNMS:Specifies the IP address of the NMS allowed to perform the following commands:
†update firmware
†backup
†restore
†reboot
SmartCell ZX-250 User Guide C-7
