Applicable Models: EC-1200EC-1600

MS-10Replacing the Post Spacer

àREMOVAL

1.Remove the center cover, by referring to the Section MS-19 "Replacing the Center Cover of Upright Type."

2.Remove the lock nut located at the side of the frame, and then remove the adjust screw. (Fig. 1)

3.Pull out the spacer spring. (Fig. 1)

4.The post spacer can be pulled out upward while the boss at the side of the post is being pressed in with a screwdriver (for both right and left sides). (Fig. 2)

àASSEMBLING

1.Insert a brandnew post spacer.

2.Insert the spacer spring, and slightly fasten the adjust screw. (Fig. 3)

3.Insert the seat post (handleber post), and adjust the adjust screw so that the post will drop slowly.

4.Fasten the lock nut to lock the adjust screw.

5.Assemble the center cover, by referring to the Section MS-19 "Replacing the Center Cover of Upright Type."

Spacer Spring

Adjust Screw

Lock Nut

Fig. 1

Lock Nut

Adjust Screw

Post Spacer

Boss

Press in.

Fig. 2

Fig. 3

Cateye Ergociser Series 1000 Service Manual

MS-10Replacing the Post Spacer

47

Page 49
Image 49
Cateye EC-3600, EC-3700 service manual MS-10Replacing the Post Spacer