Cateye EC-3700 service manual MS-3Adjusting the Flywheel, EC-1600 EC-3600

Applicable Models: EC-1600 EC-3600 EC-3700

MS-3Adjusting the Flywheel

àAdjustment Method of Flywheel

Since the plain belt which delivers the rotation of both the workload unit and flywheel requires an adequate tension, a specified tension should be given to the plain belt in the following adjustment procedures. For this adjustment, use commercial tools, since no purpose-designed tool is not prepared.

1.Set a commercial wire around the flywheel metal base as depicted in Fig. 1, and tie up the both ends outside the frame.

2.Hang a commercial spring scale at the top of the wire thus tied up, and lift the scale upward with a pulling force of 5 to 6 kg.

3.Keeping this status, fully tighten the four metal base fixing screws which had been fastened provisionally. (Fig. 2)

Spring Scale

Flywheel

Wire

Metal Base Fixing Screws

Flywheel Metal Base

Fig. 1

Flywheel Metal Base

Metal Base Fixing Screw

Fig. 2

MS-3Adjusting the Flywheel

Cateye Ergociser Series 1000 Service Manual

39