Cateye EC-3700, EC-3600 MS-19Replacing the Center Cover of Upright Type, EC-1200 EC-1600

MS-19Replacing the Center Cover of Upright Type

	Applicable Models:	EC-1200	EC-1600
MS-19Replacing the Center Cover of Upright Type
1.	Loosen the four screws on the bottom of the control unit,
	remove the control unit, and then detach the cable connector.			Handlebar Post
	(Fig. 1)
2.	For EC-1600, slide the inner pipe of the handlebar post cover
	upward, and detach the 5P cable connector (Fig. 2). For EC-		5P Cable	Handlebar Post Cover
	1200, remove the cable holder from the handlebar post.
			5P Cable
3.	Loosen the handlebar post knob, and pull out the handlebar
	post from the main unit. (Fig. 3)
4.	Pull the seat post knob upward, and pull out the seat post from
	the main unit. (Fig. 4)
5.	Loosen and remove the guide screw of the seat post knob.
	(Fig. 5)			Handlebar Post Knob
6.	Remove the rubber base of the seat post knob. (Fig. 6)	Fig. 1	Fig. 2	Fig. 3
7.	Slightly loosen the center cover fixing screws (6 pieces), and
	remove the center cover by pulling it upward. (Fig. 7)		Seat Post Knob
8.	The assembling of the center cover can be made in the
	procedures opposite to the above.
			Seat Post
		Seat Post Knob
				Rubber Base
				Guide Screw
		Fig. 4	Fig. 5	Fig. 6
		Center Cover
		Center Cover
		Fixing Screws
		Fig. 7
Cateye Ergociser Series 1000 Service Manual
56