Cateye EC-3600, EC-3700 service manual ES-2Replacing the 5P Cable

Applicable Models: EC-1200 EC-1600 EC-3600 EC-3700

ES-2Replacing the 5P Cable (1)

Procedures are different depending on the type of model as shown below:

àUpright Type (EC-1200)

T Removing the Existing Cable

1. Loosen the four screws which fix the control unit to remove the control unit. Also, remove the cable connector. (Fig. 1)

2. Remove the cable holder which fixes the 5P cable to the handlebar post.

3. Remove the frame cover. (See the Section D-1 "Removing the Frame Covers.")

4. Remove the CN-2 connector from the power supply board. (Fig. 2)

5. Cut the cable holders which fix the 5P cable to the frame, and remove the 5P cable.

T Mounting the Brand New Cable

1. Mark the 5P cable at a point approx. 87cm from the unit-side cable connector (Fig. 3), and connect the leading end of the CN-2 connector to the power supply board.

2. (1)Using cable holders, fix the 5P cable at the bottom of the handlaber pipe of the main unit frame.(2)Fix the cable at the marked point of the cable to the handlebar pipe just beneath the horizontal frame.(3)Pass the 5P cable along with the handlebar pipe, and the sagging portion should be binded with a cable holder. (Fig. 4)

3. Connect the cable connector to the control unit, and apply the connector cover.Then, fix the control unit to the handlebar post by using four screws. (Fig. 1)

4. Provisionally turn on the power, and check if the control unit works fine.

5. Fix the 5P connector to the handlebar post with the cable holder.

6. Mount the frame cover. (See the Section D-1 "Removing the Frame Covers.")

àUpright Type (EC-1600)

TRemoving the Existing Cable

5P Cable Handleber Post

1.Loosen the four screws which fix the control unit to remove the control unit. Also, remove the cable connector. (Fig. 4) Slide the inner handlebar post cover upward, and unplug the cable connector. (Fig. 5)

2.Remove the screws of both the handlebar stem and the outer handlebar post cover to remove the 5P cable. (Fig. 6)

5P Cable within the Frame

1.Remove the frame cover. (See the Section D-1 "Removing the Frame Covers.")

2.Remove the CN-2 connector at the end of the 5P cable from the power supply board.

3.Cut the cable holders which fix the 5P cable to the handlebar pipe, and remove the 5P cable.

To be continued on the next page.

Cable

Connector

Screws

EC-1200

Fig. 1

Handlebar Pipe

Horizontal Frame

(2)

(3)

Cable Holders

(1)

EC-1200

Fig. 4

Handlebar Stem

Cover

Screws

Power Supply Board

Fig. 2

Cable

Connector

Screws

EC-1600

Fig. 5

5cm

Cable Connector

Cable Holder

Unit-Side Cable Connector

Mark this point.

87cm

Fig. 3

Inner Handlebar Post Cover

Unplug

Fig. 6

-2Replacing the 5P Cable (1)

Fig. 7 Fig. 8

Cateye Ergociser Series 1000 Service Manual

ES

25