Cisco Systems 11500 Series manual Reboot the CSS to boot the module, Modules

Chapter 2 Cabling and Troubleshooting the CSS

Troubleshooting the CSS Hardware Components

Table 2-12 Troubleshooting the CSS Modules (continued)

Symptom	Recommended Action
During normal CSS operation,	The Switch Module in slot 1 failed.
the following message appears	1.	Power down the CSS.
and then, the CSS reboots:
	2.	Remove and replace the module. Refer to
ONDM: Port C Path Failure
		the reference sheet that comes with the
%s, turning off Focus-C
		replacement module.
Port.
	3.	Reboot the CSS to boot the module.
During normal CSS operation,	The Switch Module in slot 2 failed.
the following message appears	1.	Power down the CSS.
and then, the CSS reboots:
	2.	Remove and replace the module. Refer to
ONDM: Port D Path Failure
		the reference sheet that comes with the
%s, turning off Focus-D
		replacement module.
Port.
	3.	Reboot the CSS to boot the module.
During normal CSS operation,	The Switch Modules in slot 1 and 2 failed.
the following message appears	1.	Power down the CSS.
and then, the CSS reboots:
	2.	Remove and replace the modules. Refer to
ONDM: Both Port C and Port
		the reference sheet that comes with the
D Focus Connect paths have
		modules.
failed.
	3.	Reboot the CSS to boot the modules.
During normal CSS operation,	Check the fans in the chassis. The module in
the following message appears:	the designated slot number is running a
Temperature has reached x	temperature that is too high, indicated by the x
	variable.
celsius for slot number
	• For a CSS 11503, replace the chassis.
	• For a CSS 11506, replace the fan module.
		Refer to the reference sheet that comes
		with the replacement module.

	Cisco 11500 Series Content Services Switch Hardware Installation Guide
2-40	78-13884-06