Cisco Systems 11500 Series manual Installing a Pcmcia Cover on an SCM

Chapter 1 Unpacking and Installing the CSS

Installing a CSS Module

8.Optionally, you can install the PCMCIA cover to the front of the disk slots and secure it with its two spring-loaded screws, as shown in Figure 1-9. The cover protects the disks in the SCM.

Figure 1-9 Installing a PCMCIA Cover on an SCM

C S S 5 - S C M - 2 G E

	MANAGEMENT
		10BASE-T
STATUS	LINK/ACT		DUPLEX
			GE 1	LINK
PCMCIA			SLOT 1
			SLOT 0

GE 2 LINK

CONSOLE

System Control

59602

9.Reboot the CSS to initialize the passive SCM.

10.To copy the boot configuration from the active SCM to the passive SCM, use the passive sync command in boot configuration mode. For more information, refer to the Cisco Content Services Switch Administration Guide.

	Cisco 11500 Series Content Services Switch Hardware Installation Guide
78-13884-06		1-27