13-25
Software Configuration Guide—Release 15.0(2)SG
OL-23818-01
Chapter 13 Configuring VLANs, VTP, and VMPS VLAN Membership Policy Server
To define the primary and secondary VMPS on a Catalyst 4500 series switch, perform this task:
This example shows how to define the primary and secondary VMPS devices:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# vmps server 172.20.128.179 primary
Switch(config)# vmps server 172.20.128.178
Switch(config)# end
Note You can configure up to four VMPS servers using this CLI on the VMPS client.
Switch# show vmps
VQP Client Status:
--------------------
VMPS VQP Version: 1
Reconfirm Interval: 60 min
Server Retry Count: 3
VMPS domain server: 172.20.128.179 (primary, current)
172.20.128.178
Reconfirmation status
---------------------
VMPS Action: No Dynamic Port
Configuring Dynamic Access Ports on a VMPS Client
To configure a dynamic access port on a VMPS client switch, perform this task:
Command Purpose
Step 1 Switch# configure terminal Enters global configuration mode.
Step 2 Switch(config)# vmps server
{ipaddress | hostname} primary Specifies the IP address or hostname of the switch acting as the
primary VMPS server.
Step 3 Switch(config)# vmps server
{ipaddress | hostname}Specifies the IP address or hostname of the switch acting as a
secondary VMPS server.
Step 4 Switch(config)# end Returns to privileged EXEC mode.
Step 5 Switch# show vmps Verifies the VMPS server entry.
Command Purpose
Step 1 Switch# configure terminal Enters global configuration mode.
Step 2 Switch(config)# interface interface Enters interface configuration mode and specifies the port to be
configured.
Step 3 Switch(config-if)# switchport mode
access Sets the port to access mode.
Step 4 Switch(config-if)# switchport access
vlan dynamic Configures the port as eligible for dynamic VLAN access.
Step 5 Switch(config-if)# end Returns to privileged EXEC mode.
Step 6 Switch# show interface interface
switchport Verifies the entry.