Cisco Systems 4500 Configuring Location TLV and Location Service

27-11
Software Configuration Guide—Release 15.0(2)SG
OL-23818-01
Chapter 27 Configuring LLDP, LLDP-MED, and Location Service Configuring LLDP and LLDP-MED, and Location Service
This example shows how to enable LLDP power negotiation on interface Gigabit Ethernet 3/1:
Switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# int gi 3/1
Switch(config-if)# lldp tlv-select power-management
Configuring Location TLV and Location Service
To configure location information for an end-point and to apply it to an interface, perform this task:
Step 3 Switch(config-if)# lldp tlv-select
power-management Enables LLDP power negotiation.
Step 4 Switch(config-if)# end Returns to privileged EXEC mode.
Step 5 Switch# copy running-config
startup-config (Optional) Saves your entries in the configuration file.
Command Purpose
Command Purpose
Step 1 Switch# configure terminal Enters global configuration mode.
Step 2 Switch(config)# location {admin-tag
string | civic-location identifier id |
elin-location string identifier id}
Specifies the location information for an endpoint.
• admin-tag—Specify an administrative tag or site information.
• civic-location—Specify civic location information.
Note The civic location identifier in the LLDP-MED TLV is
limited to 250 bytes or less. To avoid receiving error
messages regarding available buffer space during switch
configuration, never allow the total length of all civic location
information specified for each civic-location identifier to
exceed 250 bytes.
• elin-location—Specify emergency location information (ELIN).
• identifier id—Specify the ID for the civic location.
• string—Specify the site or location information in alphanumeric
format.
Step 3 Switch(config-civic)# exit Returns to global configuration mode.
Step 4 Switch(config)# interface interface-id Specifies the interface on which you are configuring the location
information, and enter interface configuration mode.