Cisco Systems 4500 Changing the Quiet Period

40-81
Software Configuration Guide—Release 15.0(2)SG
OL-23818-01
Chapter 40 Configuring 802.1X Port-Based Authentication Configuring 802.1X Port-Based Authentication
This example shows how to enable 802.1X on Fast Ethernet interface 5/9 and to allow multiple hosts:
Cisco IOS Release 12.2(50)SG and later
Switch# configure terminal
Switch(config)# interface fastethernet5/9
Switch(config-if)# switchport mode access
Switch(config-if)# dot1x pae authenticator
Switch(config-if)# authentication host-mode multi-host
Switch(config-if)# authentication port-control auto
Switch(config-if)# end
Switch#
Cisco IOS Release 12.2(46)SG or earlier
Switch# configure terminal
Switch(config)# interface fastethernet5/9
Switch(config-if)# switchport mode access
Switch(config-if)# dot1x pae authenticator
Switch(config-if)# dot1x host-mode multi-host
Switch(config-if)# dot1x port-control auto
Switch(config-if)# end
Switch#
Changing the Quiet Period
When the switch cannot authenticate the client, the switch remains idle for a set period of time, and then
tries again. The idle time is determined by the quiet-period value. A failed authentication of the client
might occur because the client provided an invalid password. You can provide a faster response time to
the user by entering a number smaller than the default.
To change the quiet period, perform this task:
Command Purpose
Step 1 Switch# configure terminal Enters global configuration mode.
Step 2 Switch(config)# interface
interface-id Enters interface configuration mode and specifies the interface to be
enabled for timeout quiet-period.
Step 3 Switch(config-if)# switchport mode
access Specifies a nontrunking, nontagged single VLAN Layer 2 interface.
Step 4 Switch(config-if)# dot1x pae
authenticator Enables 802.1X authentication on the port with default parameters.
Refer to the “Default 802.1X Configuration” section on page 40-27.
Step 5 Switch(config-if)# dot1x timeout
quiet-period seconds Sets the number of seconds that the switch remains in the quiet-period
following a failed authentication exchange with the client.
To return to the default quiet-period, use the
no dot1x timeout quiet-period configuration command.
The range is 0 to 65,535 seconds; the default is 60.
Step 6 Switch(config-if)# authentication
port-control auto Enables 802.1X authentication on the interface.
Step 7 Switch(config-if)# end Returns to privileged EXEC mode.
Step 8 Switch# show dot1x all Verifies your entries.
Step 9 Switch# copy running-config
startup-config (Optional) Saves your entries in the configuration file.