28-3
UserGuide for Cisco Digital Media Manager5.4.x
OL-15762-05
Chapter28 Emulate the DMP Remote Control for Use with Cisco Cast
Concepts
Workflow to Provision Emulator Service for IP Phones
You can provision a service from Cisco Unified Communications Manager that emulates the handheld
DMP remote control unit on Cisco IP phones. This workflow assumes that you are experienced as an
administrator in Cisco Unified Communications Manager and that you use it already to manage a
network of IP phones.
Tip Skip this workflow if you will not use any IP phones to emulate the remote control.
1. Complete these tasks in CUCM.
a.
Activate Services, page 28-4
b.
Start Services, page28-5
c.
Configure URL Parameters, page 28-5
d.
Enable IP Phone Autoregistration, page 28-6
e.
Define IP Phone Service Attributes, page28-6
f.
Expose the Service to IP Phones, page 28-7
Note Emulator-related configuration changes that you make on your Cisco Unified Communications
Manager server do not become useful until after you also configure Cisco Cast to serve the
emulator, and configure at least one IP phone to run theemulator.
2. Complete these tasks in CiscoCast.
•
Configure Emulator Settings in Cast, page 28-8
3. Complete these tasks on phones, as needed.
a.
Configure an IP Phone to Emulate the Remote Control, page 28-10
b.
Start the Emulator on an IP Phone, page 28-10
c.
Start the Emulator on a Mobile Phone, page 28-11
d.
Use the Emulator on an IP Phone or a Mobile Phone, page 28-12
Note This workflow is based on Ci sco Unified Communications Manager release 6.1. When you use any other release, the
workflow might differslightly in your network. We recommend that you read on Cisco.com the particular revisions of these guides
that apply to your network.
•Cisco Unified Communications Manager Administration Guide
•Cisco Unified Serviceability Administration Guide