28-12
UserGuide for Cisco Digital Media Manager5.4.x
OL-15762-05
Chapter28 Emula te the DMP Remote Control for Use with Cisco Cast
Procedures
Use the Emulator on an IP Phone or a Mobile Phone
Before You Begin
•
(When you will use the emulator on an IP phone) Complete the workflow in Cisco Unified
Communications Manager to provision the emulator to your IP phones.
•
Configure emulator settings in CiscoCast.
•
Start the emulator on your phone.
Procedure
Step1
Consult DMP remote control documentation on Cisco.com and pay particular attention to sections that
describe button behaviors. These descriptions apply equally to the physical unit and its emulator.
Note The emulator has fewer buttons than the physical remote control has. You cannot invoke behaviors from the
emulator which correspond to any buttons that it does not have.
Step2
Stop. You have completed this procedure.
Related Topics
•
Workflow to Provision Emulator Service for IP Phones, page 28-3
•
Configure Emulator Settings in Cast, page 28-8
•
Start the Emulator on an IP Phone, page 28-10
•
Start the Emulator on a Mobile Phone, page 28-11